434 mhz saw filter 11 mhz bandwidth part number: SF0434BA02507S spectrum microwave 400 nickerson road, marlbo rough, ma 01752, usa ? phone 1-508-251-6400 ? fax 1-508-251-6401 www.spectrummicrowave.com dsSF0434BA02507S rev a 25-mar-2010 ecn 36650 page 1 of 3 description ? miniature 434 mhz surface acoustic wave (saw) bandpass filter with an 11 mhz typical 3db bandwidth used as rf filter in a low power ism trans ceiver, receiver, and transmitter application. ? 3.8 x 3.8 mm smp. ? rohs compliant. typical performance
434 mhz saw filter 11 mhz bandwidth part number: SF0434BA02507S spectrum microwave 400 nickerson road, marlbo rough, ma 01752, usa ? phone 1-508-251-6400 ? fax 1-508-251-6401 www.spectrummicrowave.com dsSF0434BA02507S rev a 25-mar-2010 ecn 36650 page 2 of 3 specification parameter min typ max units center frequency, f c - 434.0 - mhz passband 4 6 - mhz insertion loss 1 - 2.5 3.5 db amplitude ripple 1 - 1.1 1.5 db stopband rejection, 334 ? 393.2 mhz 50 55 - db stopband rejection, 474 ? 534 mhz 50 55 - db terminating impedance 50 ? notes: 1. over passband, fo +/- 2 mhz. maximum ratings parameter min max units storage temperature range -40 +85 oc operating temperature range -40 +85 oc input power level - 0 dbm max. d. c. voltage between each terminal - 10 v matching circuit note: matching components are not required. input 50 ? single-ended output 50 ? single-ended
434 mhz saw filter 11 mhz bandwidth part number: SF0434BA02507S spectrum microwave 400 nickerson road, marlbo rough, ma 01752, usa ? phone 1-508-251-6400 ? fax 1-508-251-6401 www.spectrummicrowave.com dsSF0434BA02507S rev a 25-mar-2010 ecn 36650 page 3 of 3 package outline suggested footprint marking iso 9001 registered all specifications are believed to be accurate and reliable. howe ver, spectrum microwave reserves the right to make changes wit hout notice. ? 2010 all rights reserved. package material: body: al 2 o 3 ceramic lid: kovar, ni plated terminations: au plating 1 m min, over a 1.3-8.9 m ni plating units: mm tolerances are 0.15 mm except where indicated. pad configuration: input: 2 output: 5 ground: 1,3,4,6
|